Installation & Preparation; Start-Up - Mi-T-M MV-1300-0MEV Instrucciones De Operación

WARNING
RISK OF FIRE!
Where flammable gas vapors
may be present. An electrical
spark from the motor may
cause a fire.
WARNING
RISK OF ELECTRIC SHOCK!
Where the unit may be
exposed to rain, snow or
immersed in water. Water
may infiltrate the electrical
system causing an
electrical hazard.
Wet/Dry Vac Operator's Manual
INSTALLATION & PREPARATION

START-UP:

1. Proper attire is essential to your safety. It is advised to utilize whatever means
necessary to protect eyes, ears, and skin.
2. Remove the Canister Lid by releasing the Side Latches.
a. Inspect the Wet/Dry Filter to ensure it is free of obstructions. Clean or replace
if necessary.
b. Inspect the Canister to ensure it is empty and free of obstructions.
c. If repairs are needed, contact your Authorized Service Center and replace
with only genuine manufacturer replacement parts.
3. Filter bags are not necessary with your Mi-T-M Wet/Dry Vac. If desired, you
may attach a Paper Filter Bag (supplied with the unit) onto the Suction Intake of
the Canister for collection and immediate disposal of dry debris. Be certain the
paper filter bag is removed for wet pickup. Ensure all materials are disposed
of according to State and Federal EPA Standards.
4. Replace the Canister Lid and securely tighten the Side Latches.
5. Securely insert the larger end of the Flexible Hose sleeve into the Suction
Intake.
6. Connect the Extension Wand onto the Flexible Hose.
7. Connect the Wet/Dry Floor Tool onto the Extension Wand.
8. Ensure electrical supply is identical to the specifications listed on your Wet/Dry
Vac Data Plate.
9. Ensure the On/Off Switch is in the "OFF" position.
10. Insert the grounded plug of the Power Cord into a grounded receptacle.
7