Sanus MF215 Manual Del Usuario página 13

4. Place the wall plate template
17
template and tape in place.
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.
IMPORTANT
: Be sure you mark and drill into the center of the stud.
5. Drill the two pilot holes using a 5.5 mm (7/32 in.) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 75 mm (3 in.).
6. Remove the wall plate template
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage Do not over-
tighten the lag bolts
20
Fit lag bolt covers over lag bolts
23
4
17 at your desired height and position the slotted holes over your stud center line. Level the wall plate
17 . Tighten lag bolts
.
.
20
5
17
only until the washers
20 21
75 mm
(3 in.)
5.5 mm
(7/32 in.)
17
are pulled fi rmly against the wall plate
6
21
20
.
18
18
23
13