Model 1666 | Owner's Manual |
Care & Maintenance
CARE & MAINTENANCE
!
D A N G E R
NEVER operate this appliance
Regularly clean your appliance between uses, especially after extended
within 10ft (3.0 m) of any
periods of storage. In order to extend the life and condition of unit,
structure, combustible material
follow best practices detailed in this manual.
or other gas cylinder. NEVER
operate this appliance within 25ft
Section 01
(7.5 m) of any flammable liquid.
GENERAL CARE
VALVE CHECK
!
WA R N I N G
Ensure gas is off at LP cylinder
before checking valves. Knobs
The LP bottle/tank must be
must be locked in OFF position.
disconnected when the appliance
is not in use and must not be
01. To check valves, push in knobs
stored in the vicinity of this or any
and release. Knobs should
other appliance.
spring back.
02. If knobs do not spring back,
replace valve assembly before
!
WA R N I N G
using appliance.
When not in use, turn unit
03. Rotate knobs to LOW position
controls and gas source OFF.
then turn back to OFF position.
Knobs should turn smoothly.
FIT TINGS & HOSES
!
WA R N I N G
Annual checking and tightening of
This appliance will be hot during
metal fittings is recommended.
and after use. Use insulated oven
mitts or gloves for protection
Before each use, check to see if hoses
from hot surfaces or splatter from
are cut or worn. Replace damaged
cooking liquids.
hoses before using appliance. Use
only Blackstone approved replace-
ment parts for valve, hose, or
regulator.
!
C A U T I O N
NEVER handle hot parts with
unprotected hands.
10
GENERAL CLEANING
Ensure that the appliance and its
components are sufficiently cool
before cleaning.
• Baked-on grease deposits may
require the use of an abrasive
plastic cleaning pad. Use only
in direction of brushed finish to
avoid damage.
• DO NOT use abrasive pad on areas
with graphics.
• If a bristle brush is used to clean
any of the oven cooking surfaces,
ensure no loose bristles remain on
cooking surfaces prior to cooking.
BURNER MAINTENANCE
STORAGE
In most circumstances, burning
• In order to extend and maintain
residue off after cooking will keep
the life and condition of your
burner clean.
appliance, we strongly
recommend that the unit be
Burner should be removed and
covered when left outside for any
cleaned annually or when-
length of time, especially during
ever heavy build-up is found in
the winter months.
order to ensure that there is no
blockage in the burner portholes or
• When LP cylinder is connected
venturi tubes.
to appliance, store appliance
outdoors in a well-ventilated
Use pipe cleaner to clear obstruc-
space and out of reach of children.
tions. A wire brush may be used
LP cylinder should only be stored
to remove corrosion from the
outside, out of reach of children,
burner surfaces. (Please refer-
and in a cool, dry place.
ence the Cleaning the Burner
Assembly section)
• Store appliance indoors ONLY if
LP cylinder is turned off, discon-
When refitting burner, check that
nected, removed from appliance
the venturi tubes of the burner fit
and stored outdoors.
over valve outlets.
• When removing appliance from
storage, clean burner assembly
AF TER EACH USE
before starting appliance. (Please
reference the Cleaning the Burner
PLASTIC PARTS: Wash with warm
Assembly section.)
soapy water and wipe dry.
PAINTED SURFACES: Wash
with mild detergent or nonabra-
sive cleaner and warm soapy
water. Wipe dry with soft nonabra-
sive cloth.
STAINLESS STEEL SURFACES:
To maintain appliance frame's high
quality appearance, wash with mild
detergent and warm soapy water.
Wipe dry with a soft cloth after
each use.
Care & Maintenance
| Owner's Manual | Model 1666
!
WA R N I N G
This appliance is not intended
for and should never be
used as a heater.
!
WA R N I N G
DO NOT leave appliance
unattended. Keep children and
pets away from appliance at
all times.
!
WA R N I N G
The use of alcohol, prescription
or non-prescription drugs may
impair the consumer's ability
to properly assemble or safely
operate the appliance.
!
C A U T I O N
For residential use only. DO NOT
use for commercial cooking.
!
C A U T I O N
DO NOT use Citrisol, abrasive
cleaners, de-greasers or a
concentrated cleaner on plastic
Damage to and failure
parts.
of parts may result.
11