Pentair PROWLER 920 Guia De Instalacion página 5

IMPORTANT WARNING AND SAFETY INSTRUCTIONS
AFTER installing the cleaner, make sure the cleaner is
operating correctly:
The cleaner may need some minor adjustments to make sure
it is operating properly so there is no damage to the pool
finish. Certain vinyl liner patterns are particularly susceptible
to surface wear, pattern removal, ink rubbing off of, or
serious scratches to the pattern caused by objects coming
into contact with the vinyl surface, including automatic pool
cleaners. Pentair is not responsible for any pattern removal,
abrasions or markings on vinyl liners.
Disclaimer of Liability
About your Pool and Cleaner:
There are a multitude of factors that contribute to the life
of your pool. These robotic pool cleaners are very passive
products that will have no impact on pool life.
Please be aware that over time, deterioration, discoloration
and brittleness of any pool finish can be caused separately
by, or in combination with, age, an imbalance in pool water
chemistry, improper installation and other factors. Robotic
pool cleaners will not remove or cause wear on "good" pool
plaster. In fact, the opposite is true–pool plaster will eventually
cause wear on the cleaner.
The same situation holds true for vinyl-lined in-ground
swimming pools, because vinyl liners are also affected by
the environment and factors such as pool water chemistry,
sunlight and the pool' s surroundings. Therefore over time, vinyl
can become brittle and weak. In addition, vinyl-lined pools are
affected by the workmanship, composition and installation
of the liner and the workmanship and quality of construction
of the supporting walls and pool base. These are all factors
which can contribute to liner failure. The existence of any of
these type of conditions in your pool is not caused by the use
or operation of the cleaner. The manufacturer disclaims any
liability for repairs or replacement to any of these structures
or components of the customer' s pool.
The pool owner must assume all responsibility for the condition
and maintenance of the pool' s surface, water and deck.
SAFETY
- Connect only to a grounding type receptacle protected by a
earth leakage circuit breaker 30mA
- Keep the power supply out of standing water
- Position the power supply at least 3.5m (12 feet) away from
the edge of the pool
- Do not enter the pool while the Pool Cleaner is working
- Unplug the power supply before servicing
SAVE THESE INSTRUCTIONS
PROWLER 920 Robotic Inground Pool Cleaner Installation and User' s Guide
™
DO NOT ALLOW CHILDREN TO USE THE
CLEANER :
MAINTENANCE AND STORAGE
- Make sure that no water is left in the Pool Cleaner
- Thoroughly clean the filter and let it dry outside of the filter
canister
- Roll up the cable so that it has no kinks
- Store the Pool Cleaner in a protected area out of direct sun /
rain / frost, at a temperature of between
- 5°-45°C / 41°-113°F
- DO NOT LUBRICATE
iv