Truper CM-14N2 Instructivo página 20

Cutting Angle Adjustment
• Loosen both knobs in the rear clamp.
• Turn it into the desired angle.
• Tighten back both knobs.
• The front clamp will rotate on its axle to automatically
adjust to the work piece.
Cutting Depth Adjustment
• Loosen the safety nut.
• Turn the depth control screw into the desired height.
When it is in contact with the depth stop shows the cutter
head depth limit.
• Tighten back the safety nut.
• If the disc diameter is diminished due to wear, cutting
depth should be increased.
Disc Installation
CAUTION
• Disconnect the tool
before replacing the disc.
• Move the retractile guard up.
• Press the axel block lever inwards and at
the same time turn the disc by hand until the
axel is blocked.
• Loosen the axel screw turning in a
counterclockwise direction. Remove it all
together with the washer, the exterior platter
and the disc. DO NOT REMOVE THE INNER
PLATTER FROM THE DISC.
• Double-check the inner side of the disc
Hex Key
8
ENGLISH
Front
Clamp
Cutting Depth
Control Screw
platters are clean and free of any substance.
• Set the new disc, exterior platter, the
washer and the axel screw. Tight in a
clockwise direction just enough to firmly
support the disc. Excessive tightening could
damage the disc or the axel thread.
• Move the retractile guard downwards and
verify the shaft lock is released before turning
on the tool.
Disc
Outer Washer
Platter
Start Up
Safety
Nut
Axel Inner
Screw Platter
Rear
Clamp
Screw
Cutting
Depth
Stop
Axel
Block
Lever