Start Up - Truper CM-14N2 Instructivo

Start Up

A) Switch
Turning On and Operation Control
B) Continuous
use button
• Intermittent Operation:
Connect the plug to the outlet.
Press the switch (A) to start the operation.
To stop use, just release the switch.
• Continuous Operation:
Connect the plug to the outlet.
Press the switch (A) and lock it, pressing continuous use button (B).
To stop operation, press and release the switch.
Fastening the Work Piece
1 2
1. Lift the half-nut.
2. Pull the crank outwards.
3. Set the work piece.
4. Push the crank until it
touches the work piece.
5. Lower the half-nut.
6. Turn the crank to fasten
the work piece.
3
Crank
Half
Nut
4 5
6
Clamp
Screw
• Set the work piece in a way it cannot move while the disc is
making contact.
• Pieces in an angle shall be worked inverted.
• Cuts will be more efficient if the disc cuts the lowest thickness
section.
• Insert a metallic block slightly smaller than the work piece when
the disc diameter is worn due to wear.
CAUTION
• Never make hands-free cuts if the clamping
screw does not correctly clamp the work piece.
Metallic
Block
7
ENGLISH