S19-671HR
1b
Eyewash installation — S19-671H
Remove the plastic dust plug from the
bottom of the yoke assembly and discard.
4
9/10/2018
Attach the eyewash yoke assembly to
the tank . Max . torque 150 In-Lbs . (The
excess heater cable from the yoke
assembly will be tucked into the heater
A
jacket in a later step .) Route the power
cable through the slot on the tank's side .
NOTICE: Check to ensure the heat
trace cable from the yoke assembly
is not kinked or damaged from
assembly.
Bradley • 215-1748 Rev. C; ECN 18-05-033
Installation