Dimensions; Setup; Ac Power; Mounting - Chauvet Obey 70 Manual De Usuario

DMX Polarity
MIDI In
Switch

Dimensions

3. Setup

AC Power

Mounting

Orientation

Rigging

Page 8 of 40
Connections
Description
DMX Out
Sticker
DC Power In Strobe Out
This product requires an external power supply, which is included. The included
power supply is rated for 100~240 VAC, 50/60 Hz, 500 mA max. Before powering on
the unit, make sure the line voltage to which you are connecting it is within the range
of accepted voltages listed on the label affixed to the product or refer to the
Technical Specifications. The listed current rating indicates average current draw
under normal conditions.
Always connect the fixture to a grounded circuit. Never connect the fixture to a
rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used only as a 0 to 100% switch.
Before mounting the product, read and follow the safety recommendations indicated
in the Safety Notes.
The Obey™ 70 may be mounted in any position; make sure adequate ventilation is
provided around the product.
• Choose a location for the product that gives easy access for maintenance and
programming.
• Make sure that the structure or surface onto which you are mounting the product
can support the product's weight (see Technical Information).
• When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity and a safety cable.
Power On/Off
Fog Out
Obey™ 70 User Manual Rev. 5 ML