Kobalt KMP 4240D-06 Manual De Instrucciones página 14

ASSEMBLY INSTRUCTIONS
WARNING
Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or unfolding the handle.
• If a cable is damaged, contact an Authorized Service Dealer.
1a. Installing upper handle:
• Place the mower upright in vertical position.
• Remove the packing material from the cable.
• Remove the rubber edge guard from the
lower handle (C).
• Insert the upper handle (B) into the lower
handle (C). Insert the handle bolts (AA) and
tighten with the handle nuts (BB), using a
Phillips head screwdriver (not included).
• Repeat for both sides.
Note: Do not damage the cable while installing the
upper handle.
1b. Unfolding and adjusting handle
• Pull up on the handle holes (L) to release the
handles.
• Fold the handles up until the handle pins (M) lock
into position.
Note: Ensure both handle pins are set at the same
position for proper assembly.
1a
AA
Rubber edge
guard
1b
14
B
BB
C
M