Assembly - EarthWise TC70016 Manual Del Operador

This product must be assembled correctly before use.
1. Remove the screws (M5 X 12) and washers from
each end of the wheel frame axle. Assemble the
wheels onto the axle, then install washers and
screws (M5 X 12) to secure. (Fig. 2-1)
2. Press the hub caps into the wheels and cover the
ends of the axles. You may use a hammer to seat
them securely into the wheels. (Fig. 2-1)
3. To lower wheel frame, push the lock button on back
of motor housing to release the frame (Step A).
Lower the wheel frame (Step B) and pull out the lock
pin on lower handle section (Step C). Align lock pin
to the hole in wheel frame then release it to lock the
wheel frame in position. (Fig. 2-2)
WARNING: If any parts are damaged or missing do not
operate this product until the parts are replaced. Fail-
ure to heed this warning could result in serious per-
sonal injury. Call our customer service help line at 1-
800-313-5111 for assistance.
WARNING: Do not connect to power supply until as-
sembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
2
M5x12

ASSEMBLY

4. Slide the cord retainer onto the center handle
section. (Fig. 2-3)
5. Attach the center handle section to the lower handle
sections using the two supplied M6 J-bolts and wing
nuts. (Fig. 2-4)
6. Fasten the upper handle section to the center handle
section using the two supplied M6 J-bolts and wing
nuts.(Fig. 2-5)
7. Use the two supplied cable clips to secure the cord to
the handle. (Fig. 2-6)
M5x12
WARNING: Do not attempt to modify this product or
create accessories not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
6
M6
M6
A
C
B