Cleaning - VOSS.farming easyCUT pro Instrucciones De Operación

6. Insert the upper blade into the guide points of the
oscillating head.
7. Oil its grinding surfaces with the oil supplied
(fig. 4).
8. Push the lower blade between the loosened fixing
screws (7).
9. Position the lower blade so that the grinding
surface protrudes approx. 1.5 to 2 mm beyond the
edge of the upper blade (fig. 5).
10. Tighten the fixing screws (7) using the tool.
8

CLEANING

WARNING AGAINST ELECTRICAL VOLTAGES
Keep the device away from water or other liquids, otherwise an electric shock or
short circuit may result.
CAUTION
Keep your fingers away from the sharp edges of the blades to avoid injury.
NOTICE
Do not use aggressive solvents/cleaning agents, brushes, sharp objects or similar
for cleaning. These can damage the surface.
After each use, remove oil and hair from the clipper with a dry cloth and the cleaning
brush. Finally, oil the blades as described in section 7.3.
Also clean the head and the air filter regularly.
24
INSTRUCTION MANUAL VOSS.FARMING EASYCUT PRO
approx. 1,5
to 2 mm
Fig. 4
Fig. 5
85290 | 11 | 2020 | V2