Products Made Of Natural Stone (If Present); Varnished Products (If Present); Enamelled Products (If Present); Chromium-Components (If Present) - La Nordica NORMA S EVO IDRO DSA Manual Del Usuario

PRODUCTs MADE OF NATURAL sTONE (IF PREsENT)

natural stone has to be cleaned with very thin abrasive paper or with an abrasive sponge. Do NOT use any cleanser or fluid.

VARNIsHED PRODUCTs (IF PREsENT)

after some years of product use a change in the varnished details colour is totally normal. This is due to the considerable temperature range
the product is subject to whenever in use and to the varnish ageing of time passing by.
ATTENTION: before any possible application of the new varnish, do clean and remove all the traces from the surface which has to
be varnished.

ENAMELLED PRODUCTs (IF PREsENT)

for the cleaning of enamelled surfaces use soap water or not aggressive and not chemically abrasive detergents.
after the cleaning do NOT let soapy water or any cleanser dry but remove them immediately.
DO NOT use sandpaper or steel wool.

CHROMIUM-COMPONENTs (IF PREsENT)

if the components become bluish due to overheating, this can be solved with a suitable product for cleaning. DO NOT use abrasives or
solvents.

MAINTENANCE ON THE WATER sYsTEM

excessive incrustation deposits on the inner walls of the hearth considerably reduce the efficiency of heat exchange; therefore,
remove these deposits using a steel brush whenever necessary. Never use corrosive substances that can damage the thermo-
fireplace and the boiler.
With the system switched off, once a year carry out the following checks:
• Check the operation and efficiency of the blowdown and safety valves. if they are defective, contact your authorised installer. IT Is
sTRICTLY FORBIDDEN TO REMOVE OR TAMPER WITH THE sAFETY DEVICEs.
• Check the thermal insulation of the filling pipe and the safety pipe.
• Make sure that the system is filled and under pressure, checking the water level in the expansion tank; also check that it is working
properly and check the efficiency of the safety pipe.

CALCULATION OF THE THERMAL POWER

There is not an absolute rule for calculating the correct necessary power. This power is given according to the space to be heated, but it
depends also largely on the insulation. on an average, the calorific value necessary for a properly insulated room is 30 kcal/h per m
external temperature of 0°C).
Given that 1 kW corresponds to 860 kcal/h, it is possible to adopt a value of 35 W/m
Let's suppose one wishes to heat a room of 150 m
W/m = 5250 W or 5,25 kW. as main heating, a 8 kW device is therefore sufficient.
3
Fuel
Dry wood (15% humidity)
Wet wood (50% humidity)
Wood briquettes
Brown coal briquettes
normal anthracite
Coke
natural gas
naphtha
electricity
36
(10 x 6 x 2.5 m) in an insulated apartment. in this case, it is necessary to have 150 m
3
Approximate combustion value
Unit kcal/h
kg 3600
kg 1850
kg 4000
kg 4800
kg 7700
kg 6780
m 7800
3
L 8500
kW/h 860
ENgLIsH
3 .
Required quantity in relation to
1 kg of dry wood
kW
4.2
2.2
5.0
5.6
8.9
7.9
9.1
9.9
1.0
(for an
3
x 35
3
1,00
1,95
0,84
0,75
0,47
0,53
0,46
0,42
4,19