Installing The Belt Hook - Bostitch FN1664 Manual De Operación Y De Mantenimiento

INSTALLING THE BELT HOOK

Always disconnect tool from air supply before making adjustments or before attempting any
part assembly or disassembly.
Always remove the belt hook from the tool when selecting Contact Trip Mode.
1. Assure that the sequential trip mode is selected.
2. Depress the belt hook release button on the belt hook body.
3. Slide the belt hook into the belt hook attachment slot.
4. Release the belt hook release button and check to ensure that the belt hook is locked in position.
1
USING THE INTEGRATED PENCIL SHARPENER
A standard pencil sharpener is integrated into the belt hook for the operator's convenience. To sharpen a
pencil, insert any standard pencil into the hole and rotate the pencil to the right (clockwise)to sharpen.
HEX WRENCH STORAGE
A 3mm hex wrench for servicing the tool is stored within the belt hook. To remove the hex wrench, push out
the short end of the hex wrench from the backside of the belt hook. Then grasp the hex wrench from the front
of the belt hook and remove.
2
3
-10-
4