Trigger Lockout & Selecting Trip Mode - Bostitch FN1664 Manual De Operación Y De Mantenimiento

Ocultar thumbs Ver también para FN1664:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TRIGGER LOCKOUT CONTROL
The trigger lockout control feature on BOSTITCH pneumatic tools provides
a trigger lock feature for added safety control. Push the lockout control
button in or out to activate or lock the tool trigger.
TRIP OPERATION MODE
Warning: Always disconnect air supply before making adjustments as accidental actuation may occur,
possibly causing injury.
The FN1664 features a selectable trigger system that allows the user to choose between the following
modes of operation:
1. Contact Trip Operation
1. CONTACT TRIP:
The common operation procedure on "Contact Trip" tools is for the operator to contact the work surface to
actuate the trip mechanism while keeping the trigger pulled, thus driving a fastener each time the work
surface is contacted. This will allow rapid fastener placement on many jobs. All pneumatic tools are subject
to recoil when driving fasteners. The tool may bounce, releasing the trip, and if unintentionally allowed to re-
contact the work surface with the trigger still actuated (finger still holding the trigger pulled) an unwanted
second fastener will be driven.
2. SEQUENTIAL TRIP:
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This
makes accurate fastener placement easier. The Sequential Trip allows exact fastener location without the
possibility if driving a second fastener on recoil as described under "Contact Trip". The Sequential Trip Tool
has a positive advantage because it will not accidentally drive a fastener if the tool is contacted against the
work surface - or anything else - while the operator is holding the trigger pulled.
SELECTING THE TRIP MODE:
To ensure safety, the user must lock the trigger (as described above) before changing the trigger system. To
change the trip mode, rotate the mode switch in the counterclockwise direction. The mode switch will lock
automatically when the indicating arrow is pointing down to the 3 nail icon stamped into the tool frame
(Contact Trip Mode) or to a single nail icon stamped in the tool frame( Sequential Trip Mode). Unlock the
trigger to resume tool operation.
Contact Trip Mode
(trip mode selector switch pointing down)
Trigger Lockout Control Button
2. Sequential Trip Operation
-8-
Sequential Trip Mode
(trip mode selector switch pointing up)

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido