Power Saving Mode - Bostitch GF9033-E Instrucciones De Seguridad

Only for indoor use
Class II Construction (double insulated)
Before using the tool, charge the battery as follows:
1. Insert the battery into the charger:
Insert the battery firmly into the rear of the magazine,
making sure that it is inserted the correct way around.
Do not force the battery - check the rotation (Fig. 2).
CAUTION: Children should be supervised to ensure they
do not play with the appliance.
l T his product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities, or for lack of
experience and/or for want of knowledge or skills
unless they are supervised by a person responsible
for their safety. Children should never be left alone
to play with this product.
l O nly use rechargeable batteries with this charger.
CAUTION
The BG-C02-EU charger is purpose designed for these
batteries and should not be used to charge other types.
It is possible that other batteries other than those
specified will fit into the charger and some of them may
light up the charging light.
However, this may cause permanent damage to both the
charger and the battery.
2. Plug the power cord into the mains supply. Connecting
the power cord will turn on the charger (the charging
indicator light will then show).
Red light indicates charging
Green light indicates the battery
is fully charged
CAUTION
If the charging indicator light does not show, pull out the
power cord and check the battery is mounted correctly
in the charger.
About 60 minutes is required to fully charge the battery
at a temperature of about 20°C. The charging light will
go off to indicate that the battery is fully charged.
The battery charging time becomes longer when the
temperature is low or if the voltage of the power source
is too low.
If the charging indicator light does not go off even after
more than 120 minutes have elapsed, stop the charging
and contact your BOSTITCH AUTHORIZED SERVICE
CENTER.
CAUTION
If the battery is heated due to direct sunlight, etc., just
after operation, the charging indicator may not light up.
If this occurs, cool the battery first, then start charging
again.
Recharging time: Table 1 shows the recharging time
required according to the type of battery.
Table 1: Recharging time (approx. mins) at 20°C
Battery Capacity (Ah)
Battery
voltage (V)
1.6 Ah
6V BG-B03-EU
NOTE: The recharging time may vary according to the
ambient temperature.
3. Disconnect the charger power cord.
4. Hold the charger firmly and pull out the battery
NOTE: After charging, pull out batteries from the charger
first, and store properly.. Do not store the batteries in the
charger .

POWER SAVING MODE

If the tool has not been used for about an hour with
the battery still installed, the Power Saving Mode turns
on to minimize unnecessary consumption of battery
power. Power Saving Mode is also activated when the
battery power is extremely low or there's a fault with the
machine, so please pay attention to the battery indicator
light after reactivating the tool. This is done by removing
the battery and reinstalling it).
2. Insert fuel cell into the tool
i. Pulling the latch and open the cell cover (Fig.6a & 6b).
ii. Insert the fuel cell into the tool (Fig. 7).
iii. Insert the stem of fuel cell into the hole of adaptor
(Fig. 8).
iv. Close the cell cover.
3. Load nails (see the section below 'LOADING THE
TOOL')
GB
60 mins.
9