Daily cleaning after a wet shave
1. Before cleaning, pull the 5 V plug
2. Use the On/Off switch
3. Hold the shaver over the sink.
4. Depress both release buttons
5. Pull the shaver head
6. Wash the shaver head thoroughly under warm running water on the inside
and outside (see fig. G).
7. Carefully dry the shaver head with a lint-free cloth or a paper towel. In the
process, do not push the shaving foils in.
8. Thoroughly rinse off the top part of the shaver and the shaver blades under
warm running water (see fig. H).
9. Use the On/Off switch
for approx. 5 – 10 seconds to dispel any drops of water off of the shaver
4
blades
.
10. Use a lint-free cloth or a paper towel to thoroughly dry off the shaver.
11. Firmly mount the shaver head on the shaver until the locking mechanism
audibly engages (see fig. F).
12. Place the protective cap
The shaver is now ready for use again.
Weekly cleaning
It is recommended that you thoroughly clean the shaver once a week. To do so,
that you
that you t
proceed as follows:
ws:
ws:
1. Before cleaning, pull the 5 V plug
aning, pull
aning, pull
2. Use the On/Off switch
n/Off sw
/Off sw
3. Hold the shaver over the sink.
4. Depress both release buttons
5. Pull the shaver head up and off.
6. Knock the shaver head out gently over a sink to remove stubbles.
7. Thoroughly wash the shaver head under warm running water from the in-
side and outside (see fig. G).
8. Carefully dry the shaver head with a lint-free cloth or a paper towel. In the
process, do not push the shaving foils in.
9. Without the shaver head mounted, use the On/Off switch
shaver on for approx. 5 – 10 seconds to dispel any stubble from the shaver
3
blades
.
AFTER SALES SUPPORT
USA
+1 877 386 8264
8
out of the shaver (see fig. A and B).
5
to turn off the shaver.
4
to release the shaver head
2
up and off (see fig. A).
5
to switch the shaver on without the shaver head
to thoroughly
to thoroughly dry
n the shaver until t
e shaver unt
1
on the shaver.
on the shaver.
n the shav
or use again.
or use again
g
g
8
out of the shaver (see fig. A and B).
5
to switch the shaver off (see fig. A).
4
to release the shaver head
Cleaning and maintenance
g
2
he shav
shav
r on without the s
on without th
ps of water off of t
of water of
2
5
to switch the
TM3Service@outlook.com
USA
(see fig. E).
(see fig. E).
17