D-Link DAP-3760 Guía De Instalación Rápida página 11

The DAP-3760 is shipped with a grounding wire. The unit must be
properly grounded to protect against power surges. The grounding
point can be found on the bottom of the unit. It is supplied with an
appropriate grounding lug for attachment to the ODU.
To power up the DAP-3760, follow the steps bellow:
1. Plug a user-supplied Cat-5 Ethernet cable from your wired LAN (or
a computer) into the power injector RJ-45 jack (DATA IN);
2. Plug a user-supplied Cat-5 Ethernet cable from the DAP-3760 into
the power injector RJ-45 jack (P+DATA OUT);
3. Connect the power module to the power injector and plug the AC
cord into an AC power receptacle.
4. After being powered on, the device will send out the beep sound
lasting about 1.5 seconds, informing you that the DAP-3760
powered up! Wait for about 60 seconds the system will be initialized
and start working.
11
Ground the wire
Power On
D-Link DAP-3760