Craftsman 919.152162 Manual Del Propietário página 13

Check Valve: When the air
compressor is operating, the check
valve is "open", allowing compressed
air to enter the air tank. When the
air compressor reaches "cut-out"
pressure, the check valve "closes",
allowing air pressure to remain inside
the air tank.
Check
Valve
Motor Overload Protector (not
shown): The motor has an automatic
reset thermal overload protector. If
the motor overheats for any reason,
the overload protector will shut off the
motor. The motor must be allowed to
cool down before restarting. The com-
pressor will automatically restart after
the motor cools.
HOW TO USE YOUR UNIT
How to Stop
Set the On/Off switch to "Off" .
Before Starting
read this instruction manual for
safety, operation and maintenance
instructions.
Before Each Start-Up
1. Set the On/Off switch to "Off".
2. Plug the power cord into the
correct branch circuit receptacle.
(Refer to Voltage and Circuit
Protection paragraph in
the Installation section of
this manual.)
3. Turn the regulator knob counter-
clockwise to set the outlet
pressure to zero.
4. Attach hose and accessories.
grasp air hose in hand when
installing or disconnecting to
prevent hose whip.
Do not operate
this unit until you
Risk of unsafe
operation. Firmly
use damaged or worn accessories.
NOTE: The hose or accessory will
require a quick connect plug if the air
outlet is equipped with a quick con-
nect socket.
pressure causes a hazardous risk of
bursting. Check the manufacturer's
maximum pressure rating for air
tools and accessories. The regulator
outlet pressure must never exceed
the maximum pressure rating.
air from the unit may contain water
condensation and oil mist. Do not
spray unfiltered air at an item that
could be damaged by moisture.
some air tools and accessories
may require filtered air. Read the
instructions for the air tools and
accessories.
How to Start:
1. Set the On/Off switch to "On"
and allow tank pressure to build.
Motor will stop when tank pressure
reaches "cut-out" pressure.
2. Turn regulator knob clockwise to
increase pressure and stop when
desired pressure is reached.
is noticed, stop the compressor
immediately and have it checked by
a trained service technician.
The compressor is ready for use.
13 - ENG
Risk of unsafe
operation. Do not
Risk of Bursting.
Too much air
Risk of Property
Damage. Compressed
If any unusual
noise or vibration