Floor Cleaning Tips; Cleaning Extremely Dirty Floors - Duplex STANDARD Manual De Instrucciones

DUPLEX 340/420/620
ASSEMBLING THE APPLIANCE
6.6

FLOOR CLEANING TIPS

The original DUPLEX brushes are tested and balanced individually with special electronic
instruments and guarantee the absence of vibrations that could generate mechanical
stress for the appliance and the floors.
The brushes can have different colours according to their use characteristics:
BRUSH COLOUR
Light grey
Black
(soft)
Black
(hard)
Yellow
Brown
Dark grey
(Tynex)
6.6.1

CLEANING EXTREMELY DIRTY FLOORS

Reaction phase:
Let the detergent to act on the floor and allow the brushes and / or steam to remove the dirt.
To disable the detergent recovery device, proceed as follows:
1) Stop the appliance (if in operation).
2)
Put the MOP-UP lever in the up position.
Then, by positioning the MOP-UP lever downwards the automatic dirty water recovery
system will be re-activated.
All-purpose for light dirt of all types of flooring (standard
supply).
All-purpose for heavy dirt and less delicate floors.
For scraping off resistant dirt.
For this kind of use, it is sufficient to fit the appliance with one
"hard" brush combined with a black "medium hard" brush.
For cleaning carpets, rugs, wooden floors and particularly
delicate floor surfaces.
Polishing brushes for polishing smooth surfaces.
Very abrasive brushes used for removing paint, lime, cement
deposits and other products, even when dried hard on
industrial and resistant floors: stoneware, porphyry, clinker,
terracotta etc. (These brushes can be used normally with
water and detergents).
For this kind of use, we recommend using one Tynex brush
combined with a softer, grey, all-purpose brush or black
medium hard brush.
CAUTION: due to their abrasive power they may cause
damage to floors.
106
USE
Rev.
1.0