Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
hose that delivers steam to the iron steam wand/nozzle. This prevents water
leakage (the steam iron must always be held in such a way as not to harm the
operator.
4.
To adjust steam flow, regulate the steam adjustment tap (fig. 5 #6: solenoid
valve).
5.
The Boiler is now ready for use. During use, the "steam ready" pilot light
switches on and off (C).
ATTENTION: Make sure that water is always available for the steam generator, the
lack of water can cause air bubbles inside the conduit, i.e. the water will not reach
the Boiler while the Boiler is under pressure. Without water, the pump will function
for about a minute; after that the alarm will sound and will cause the automatic
shut down of the entire unit.
6.
Water pressure should never go over 3.5 lbs, otherwise the pump will stop
and, accordingly, the water will not reach the Boiler.
IMPORTANT
1.
Use only tap water.
2.
Flush the Boiler once a week, making sure that the unit is shut off and that
the Boiler pressure is not over 0 lbs (pressure gauge). Open exhaust tap
slowly (water discharge). During this operation wear appropriate regulation
gloves, in order to avoid burns.
3.
Never leave hot iron on the ironing board.
4.
Connect the Boiler to suitable protected plug.
5.
When not in use, switch the Boiler off and close the water tap; remember to
open the water tap before switching on the machine again (only for the units
connected to the direct waterfeed).
6.
Always keep children away from the Boiler, both when it is on and off.
7.
Make sure that during cold seasons the tubes that connect the Boiler to water
supply do not freeze.
8.
Do not put additives in the water.
9.
Standard and extraordinary maintenance must be carried out by authorized
personnel and all the components must be replaced only with original spare
parts.
05
Publicidad
Tabla de contenido
