PAPILLON TB 280 XLN Manual De Instrucciones página 16

Cod. 99009 TB 280XLN
1) Observe the instructions on maintenance and on changes of accessories and/or
consumable tools.
2) Regularly check the cable and, if it is damaged, have it replaced by a specialised
technician. Make sure that extension cables are suitable and undamaged and fully
unwound from the winding drum (with a minimum diameter of 1 mm
Always keep the grips dry and free of oil or grease.
Avoid unwanted starts by accidentally turning ON the switch while moving the
•
machine. Always make sure that the machine's switch is OFF before plugging the
cable to the electrical mains.
Always take maximum care, accurately observing the execution of the work, with
•
good awareness and without any distractions.
Check if the tool is efficient and without any faults or damage. Check all the following:
•
operation of moving parts, any failures, correct installation of all parts and all the other
conditions which could negatively affect efficient operation of the appliance. Never
use tools with faulty switches. Any faults to the machine and/or to individual parts must
be expertly repaired by Specialised Technicians.
Original spare parts . Use original spares only.
•
Failure to observe these instructions can cause: failures, poor operation or
accidents.
* Do not remove the protective devices. To ensure protection while you work, do not
remove the protective devices and the screws from their original positions, and, in
particular, never work without the tool's protective shield.
* Make replacements with care. The wire cutting blade zone, under the protective shield,
is very dangerous. After fitting a new wire reel, resume a normal work position before
switching on the edge cutter again.
* Danger of moving parts. Do not touch the machine's moving parts or its accessories,
unless you have unplugged the machine's power cable from the electric mains.
* Protection against electric shocks. While using the appliance, avoid contact with objects
placed on the ground, such as pipes, thermosiphons, ovens and other household
electrical goods with a power cable, and wear shoes with insulating, dry soles.
Do not cut wet grass. Therefore, do not use the edge cutter in the rain
* Consider maximum acoustic pressure (noise). Wear a protective head-set to safeguard
you against the machine's noise during work, if the noise exceed 85 dB(A).
* Avoid impact. Do not press the head against the ground while using the machine, to
avoid braking motor rotation. Never strike the head on hard ground with too much force,
because you could unbalance the motor shaft.
16
).
2