Panasonic TY-ST50VX100 Instrucciones De Instalación página 2

Precautions with regard to setting up
WARNING
Do not install in a location that cannot support the entire load.
• If the pedestal is not installed correctly, the Plasma Display may fall over and become damaged, and personal
injury may result.
Do not disassemble or modify the pedestal.
• Otherwise the unit may fall over and become damaged, and personal injury may result.
CAUTION
Do not use any display other than those given in the catalogue.
• If this is not done, the unit may fall over and become damaged, and personal injury may result.
Do not climb up onto the pedestal or use it as a step. (Young children should be made particularly aware of
this caution.)
• If the unit falls over or becomes damaged through misuse, injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
• If you use the pedestal whilst it is physically damaged, personal injury may result.
Set up on a stable, level surface.
• If this is not done, the unit may fall over and become damaged, and personal injury may result.
Keep the unit away from direct sunlight and heating equipment.
• Failure to do so may result in warping, deformation, or degradation of materials, and a loss of strength that may
cause the equipment to fall over or break and cause injury.
During setting-up, make sure that all screws are securely tightened.
• If suffi cient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be
strong enough to support the Plasma Display, and it might fall over and become damaged, and personal injury may
result.
Use the accessory parts for fall-prevention to secure the Plasma Display.
• If the unit is knocked or children climb onto the pedestal with the Plasma Display installed, the Plasma Display may
fall over and personal injury may result.
When installing or removing the plasma display and pedestal, ensure that the work is done by at least three
persons.
• If more than three people are not present, the display may be dropped, and personal injury may result.
Leave a space of at least 10 cm (3.9 inches) at the top, left and right, and at least 7 cm (2.8 inches) at the rear,
and keep the space between the bottom of the display and the floor surface.
• Do not cover the air inlet holes and air outlet holes, or a fire may result.
Notes on handling
1) If the unit is placed in direct sunlight or next to a stove, the light and heat may cause discoloration or deformation.
2) Cleaning
Wipe the surfaces with a soft, dry cloth. If the unit is particularly dirty, clean it using a cloth soaked with water to
which a small amount of neutral detergent has been added, and then wipe with a dry cloth.
Do not use products such as solvents, thinner or household wax for cleaning, as they can damage the surface
coating.
(If using a chemically-treated cloth, follow the instructions supplied with the cloth.)
3) Do not attach sticky tape or labels, as they can make the surface of the pedestal dirty.
Notes on installing the pedestal
• Insert the mains plug into a mains socket which is close and easily accessible for the plasma display.
• Provide adequate ventilation so that the temperature around the display does not rise above 40°C (104 °F). If there
is insufficient movement of the air inside the display, heat may build up inside the display and fire may result.
2