Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LED-SIGNAL
AUX
LED flashes
INSTALLATION
The sensor should
be mounted firmly
to avoid extreme
vibrations.
MAINTENANCE
SAFETY
The door control unit
and the door cover
profile must be correctly
grounded.
•
The device cannot be used for purposes other than its intended use. All other uses cannot be guaranteed by the
manufacturer of the sensor.
•
The manufacturer of the door system is responsible for carrying out a risk assessment and installing the sensor and
the door system in compliance with applicable national and international regulations and standards on door safety.
•
The manufacturer of the sensor cannot be held responsible for incorrect installations or inappropriate adjustments of
the sensor.
75.5785.08 IXIO-ST UL INDUSTRIAL 20161220
Presence
detection
LED flashes x
times
x
Do not cover the sensor.
It is recommended to clean
the optical parts at least once a
year or more if required due to
environmental conditions.
Only trained and
qualified personnel may
install and setup the
sensor.
LED flashes
red-green
Avoid moving objects
and light sources in the
detection field.
Always test the
proper opration of
the installation before
leaving the premises.
LED flashes
LED is off
quickly
Avoid highly reflective
objects in the infrared
field.
Do not use aggressive
products to clean
the optical parts.
The warranty is invalid if
unauthorized repairs are made
or attempted by unauthorized
personnel.
Page 7 of 8
Publicidad
Tabla de contenido
