Turning On The Gas Grill; Turning Off The Gas Grill - Enders SAN DIEGO 2 Manual De Uso Y De Cuidado

SAN DIEGO 2

TURNING ON THE GAS GRILL

Before grilling with the gas grill for the first time, allow
the burners to burn for 15 minutes without any grill
items, to remove residue from preserving agents. This
can lead to a slightodour development. Provide for suf-
ficient ventilation. The colour of the lid and the firebox of
the gas grill can slightly change. This is a natural pro-
cess and does not constitute a complaint.
1. Open the lid of your grill.
2. You can ignite the burners independent of one
another.
3. First, turn all control knobs clockwise to the OFF
position " " and then, open the valve on the gas
cylinder!

TURNING OFF THE GAS GRILL

To turn off the grill, close the valve on the gas cylinder
and turn all control knobs to the " " position.
MEANING OF THE SYMBOLS ON THE CONTROL PANEL
You can start and control the second burner from the left with this button.
These symbols show you the different grill zones, which you can control individually
4. Press one of the control knobs and turn it counter-
clockwise to the highest setting "+". When doing so,
you can hear a CLICK. The burner ignites. If the burner
does not ignite, turn the knob back to the OFF position
" " and repeat these steps 3 to 4 times.
5. ATTENTION: If the burner does not ignite, turn the
control knob clockwise to the OFF position "
close the valve on the gas cylinder. Wait 5 minutes
and start with step 4 after opening the valve on the
gas cylinder again.
6. When the one burner has ignited, repeat step 4, to
ignite the other burners.
7. Regulate the heat by turning the control knob to
any setting between the highest setting "+" and the
lowest setting "-".
Grill Zone
on the appliance.
9
8114630
" and