Faucet Installation - Black and Decker Pfister Delton 35 Serie Guia De Inicio Rapido

Thank you for purchasing this Pfister product. All Pfister products are carefully engineered, and factory tested to provide long
trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated
instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE Plumber's Tape • Plumber's putty
• Adjustable wrench • Pliers
• Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.

FAUCET INSTALLATION

4
BOTTOM GROOVE
4B
4A
ENGLISH
• Slotted screwdriver
• Flashlight
4C
2
4 FAUCET INSTALLATION
Ensure that Putty Plate (4A) is pressed on the Deck Plate (4B). Place a bead of plumber's
putty in the grooves of the Putty Plate (4A). If desired, place a small bead of plumber's
putty to the underside of the Hose Guide Flange (4C). Install the Deck Plate (4B) and
align the Hose Guide Flange (4C) over the holes in the sink. Be sure that the "Pfister"
marking is facing forward.
5
5C
5D
5 SECURING FAUCET
From underneath sink, secure the Hose Guide (5A) by screwing the Plastic Locknut
(5B). Secure Deck Plate (5C) by screwing Wing Nuts (5D) to Mounting Posts (5E).
Hand tighten.
Caution: do not over-tighten. Remove any excess putty from around the outside
edge of Deck Plate (5C).
6
6D
6D
6E
6C
6 SIDE SPRAY INSTALLATION
Insert the Side Spray Hose (6A) through the Hose Guide (6B). From underneath sink,
push Hose Connector (6C) onto receiving Tube (6D) until unable to push any further.
To remove Hose, press on the Tabs (6E) and pull Hose Connector (6C) down.
5A
5D
5B
6B
6C
6A