LG GCWL1069CS4 Manual De Instrucciones página 58

58
PROGRAMMING MODE - SETUP MODE
25. How to change the water level
You can change the water level amongst three options.
1. indicate water level 23.8 [KHz]
2. indicate water level 23.5 [KHz]
3. indicate water level 23.0 [KHz]
Enter setup mode.
You will see LqC1
NOTE
• This function can be set only at the machine. It cannot be managed via the setup card.
(It is not applied in setup card.)
Press the Hot button.
Press the Warm or the Cold button until
in the display.
Press the Start button.
Press the Warm or the Cold button until
in the display.
Press the Start button. Display
Press Warm or Cold button to select course.
: Hot course
: Warm course
: Cold course
: Delicates course
: None (only for Heater model)
Press the Start button.
Press Warm(+) or Cold(-) button and then select
or or
23.8 [KHz]
Press the Start button.
The machine sets up the value of water level, then
advances to the next process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready
mode.
• Coin type – Turn on/off toggle switch.
• Card type – Insert the service card.
• All types – Push the Hot button three times.
Button
.
23.5 [KHz] 23.0 [KHz]
Display
appears
appears
One or the other
will display.