Installation Procedure - Toto Vivian TL220DD Manual De Instrucciones

INSTALLATION PROCEDURE - Valves
1. Thread a mounting nut to the bottom
of the valve. Place a washer and gasket
as shown.
NOTE: the hot water valve has a red
marking on side of body.
2. Pass the valve up through the
installation hole.
Insert the gasket and fasten the
collar to the valve body until it
stops.
3. Fixate the valve by threading the
mounting nut up the valve until hand
Gasket
tight. Tighten the retaining screws
equally to secure.
Washer
Do not overtighten!
Mounting
Nut
4. Repeat steps 1-3 for remaining valve.
NOTE: Hoses to connect valve inlets to water supply lines not included.
INSTALLATION PROCEDURE - Spout
5. Place gasket under spout.
NOTE: If installing a Vivian model,
place the gasket under the décor
ring and place over mounting
hole.
Pass the supply hoses and
mounting stud through the
mounting hole until the spout
comes to rest.
Gasket
Washer
Mounting
Nut
Collar
Mounting
Mounting
Screws
Screws
Gasket
5
Gasket
Gasket
(Rubber)
(Rubber)
Washer Washer
(Metal) (Metal)
Mounting
Mounting
Nut
Nut
Collar
Collar
Gasket
Gasket
Spout*
Spout
Décor Ring
Base Ring
(Vivian models only)
(Vivian Models Only
Gasket
Gasket
Moun
Scre