Final Wiring And Assembly - Metra 99-7524B Instrucciones De Instalación

Connections to be made to the aftermarket radio:
• Connect the Yellow wire to the 12-volt battery/memory wire.
• Connect the Red wire to the accessory/ignition wire.
• Connect the Orange wire to the illumination wire. If the aftermarket radio
has no illumination wire, cap off the Orange wire.
• Cap off and disregard the Orange/White wire, it will not be used in
this application.
• Connect the Black wire to the ground wire.
• Connect the Blue wire to the antenna turn on wire.
• Connect the Blue/White wire to the amp turn-on wire, if the vehicle
is amplified.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
99-7524B

Final wiring and assembly

• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
Connections to be made to the kit:
1. Plug the 8-way connector supplied with the 99-7524 into Location 1, on the
2. For manual climate control vehicles only: Plug the 16-way connector
3. Reconnect the negative battery terminal and test the radio for proper operation.
4. Reassemble the radio and dash assemblies in reverse order of disassembly.
10
back of the 99-7524 radio housing (see diagram, on right).
supplied with the 99-7524 into Location 3 (see diagram, on right).
Note: Automatic climate control vehicles will not use this harness.