Cleaning And Care - Silvercrest SED 3.7 B2 Instrucciones De Uso

NOTICE
► It may be that the hair grows back after a few days. The
reason for this is that these hairs were too short to be
removed during the last epilation session.
6) When you are fi nished with the treatment, place the speed switch 6
to "0".
7) Clean the epilator head 2 as described in the section "Cleaning
and Care".
8) Replace the protective cap 1 on the epilator head 2.

Cleaning and Care

RISK OF ELECTRIC SHOCK
► Before cleaning, disconnect the appliance from the mains
power adapter 9 and the mains power adapter 9 from the
main power supply.
WARNING - PROPERTY DAMAGE!
► NEVER submerse the appliance in water or other liquids!
After every use clean the epilator head 2 with the supplied
■
cleaning brush q to remove loose hairs.
Disinfect the epilator head 2 regularly by spraying and cleaning
■
it with disinfectant spray.
To thoroughly clean the epilator head 2 you can remove it from
■
the appliance:
Press the two restraint fi xtures 3 together and at the same
―
time pull the epilator head 2 upwards.
SED 3.7 B2
GB
59