Dmx-512 Connection - Beamz Panther 40 Led Spot Manual De Instrucciones

DISPLAY

DMX-512 CONNECTION

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
5-pin XLR DMX Connectors.
Some manufactures use 5-pin DMX-512 data cables for DATA transmission in place of 3-pin. 5-pin DMX fixtures may be
implemented in a 3-pin DMX line. When inserting standard 5-pin data cables in to a 3-pin line a cable adaptor must be used.
The chart below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor
Ground/Shield
Data Compliment (- signal)
Data True (+ signal)
Not Used
Not Used
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal
(+) into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
Selecting the DMX starting address and DMX mode.
Press the ENTER button until "DMX", "SET" appears on the display. Now use the Up and Down buttons to select the "DMX"
menu item and confirm by pressing ENTER. "ADDR" now appears on the display and by pressing ENTER once more, you can
select the DMX start address as desired using the UP and Down buttons (A001 – A5002). After confirming with ENTER, "SAVE"
is briefly displayed on the display. To set the DMX operating mode, select the menu item "DMX", press ENTER and then use
the UP and DOWN buttons to select the menu item "CHS". Press ENTER and use the UP and DOWN buttons to select the
desired DMX mode (5Ch, 9Ch, 11Ch). After confirming with ENTER, "SAVE" is briefly displayed on the display. The
synchronous control of multiple spotlights (same model) through a DMX control unit (e.g. DMX console) can be achieved by
assigning the spotlights to an identical DMX start address and DMX mode and connecting them using DMX cables.
ENTER
MODE
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the Mode/Esc-button, browse through the submenu by pressing Up
or Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down. Confirm every selection
by pressing the Enter-button.
You can leave every mode by pressing the Mode/Esc-button. The functions
provided are described in the following schedule.
3-Pin XLR Female (Out) 5-Pin XLR Male (In)
Pin 1 Pin 1
Pin 2 Pin 2
Pin 3 Pin 3
Pin 4 – Do Not Use
Pin 5 – Do Not Use
ENTER ENTER
MODE MODE
UP
DOWN
ENTER
MODE
UP
DOWN
UP
DOWN
UP
DOWN
5