Dmx-512 Connection - Beamz MHL108 Manual De Instrucciones

DMX-512 CONNECTION

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX
input of the first unit in a DMX chain. If you wish to connect a DMX controller with other XLR outputs you will need
to use adapter cables.
1 = Shield
2 = Signal (-)
3 = Signal (+)
Connect the DMX output of the first unit in a DMX chain with the DMX input of the next unit in the chain. Always
connect the output of one unit with the input of the next unit until all units are connected. If you use a controller with
5 pin DMX connection you will need to use a 5 pin to 3 pin adapter.
Caution at the unit, the DMX cable has to be terminated with a terminator. Solder a 120 Ohm
resistor between Signal (-) and Signal (+) into a 3-pin XLR connector and plug this into the DMX
output of the last unit in the chain.
DMX SETTING
6 Channel
Channel
1
2
3
2
4
5
6
11 Channel
Channel
1
2
3
4
5
6
7
8
9
10
11
Value Description
000-255 Adjust Pan movement
000-255 Adjust Tilt movement
000-010 No function
011-200 Master dimmer
201-255 Adjust strobe from slow to fast
000-255 Red color adjustment from dark to bright
000-255 Green color adjustment from dark to bright
000-255 Blue color adjustment from dark to bright
Value Description
000-255 Adjust Pan movement
000-255 Adjust Pan fine-movement
000-255 Adjust Tilt movement
000-255 Adjust Tilt fine-movement
000-255 All dimming adjustment from dark to bright
000-255 Red LED, adjustment from dark to bright
000-255 Green LED, adjustment from dark to bright
000-255 Blue LED, adjustment from dark to bright
000-009 No function
010-248 Colour mixing
249-255 Full on
000-009 No function
010-255 Adjust strobe from slow to fast
000-127 No function
128-255 Auto/sound mode
8