QEP 10424Q Manual De Operación página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

RIP CUT
Place the tile at the front edge against the front stop (Fig. 3). Position
the tile so the line of cut is directly over the scoring line, which is the
line between the left and right pad (Fig. 4). Adjust the cutting guide
by loosening the guide knob (Fig. 4) and sliding it left or right to the
desired cutting position, and lock the cutting guide in place.
DIAGONAL CUT
The cutting guide can also assist in diagonal cuts. Push the button and
loosen the angle guide lever on the cutting guide (Fig. 5). Move tile into
the desired angle and lock guide in place.
RIP CUT
Stop
Fig. 3
MAKING THE CUT
Flip the Breaker Bar up. Then place the cutting wheel on the rear edge
of the tile. Then, while applying medium pressure, slide the wheel
forward the full length of the tile, scoring the tile surface glaze as the
handle is pushed forward (Fig 6). It is important to make one continuous
motion, scoring the surface only once per tile. After scoring, and
without moving the tile, flip the breaker bar down. Position the handle
so that the breaker foot is slightly in from the front edge of the tile and
front stop. Apply increasing pressure on the handle until the tile snaps
along the score line (Fig 7).
SCORING
Fig. 6
Scoring
line
Fig. 4
Slide to
score
surface
glaze
- 3 -
Guide
DIAGONAL
knob
CUT
Breaker Bar
SNAPPING
Fig. 7
Angle
guide
lever
Fig. 5
Press
down

Publicidad

Tabla de contenido
loading

Tabla de contenido