D-Link DIR-610N Guía De Instalación Rápida página 4

TROUBLESHOOTING
SETUP AND CONFIGURATION PROBLEMS
1. HOW DO I CONFIGURE MY DIR-610N ROUTER MANUALLY?
- connect your pc to the router using an ethernet cable.
- open a web browser and enter the address http://dlinkrouter.local.
- the default username is 'admin'. the default password is '' (leave the field blank).
- If you have changed the password and can not remember it, you will need to reset the router to
set the password back to '' (leave the field blank).
2. HOW DO I RESET MY DIR-610N ROUTER TO FACTORY DEFAULT SETTINGS?
- ensure the router is powered on.
- press and hold the reset button at the bottom of the device for 10 seconds.
note: Resetting the router to factory default will erase the current configuration settings. to re-
configure your settings, log into the router as outlined in question 1, then run the setup Wizard.
3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY
WIRELESS NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?
- For every pc that needs to connect to the router wirelessly, you will need to ensure you use the
correct Wireless network name (ssId) and encryption key.
- use the web based user interface (as described in question 2 above) to check or choose your
wireless settings.
- Make sure you write down these settings so that you can enter them into each wirelessly
connected pc. You will find a dedicated area on the back of this document to save this important
information for future use.
4. WHY CAN I NOT GET AN INTERNET CONNECTION?
- For cable network users, please log in web based user interface to make sure the Mac clone
address is set up properly in the Internet settings.
- For broadband network users, please log in web based user interface to make sure the user
name and password are correct in the Internet settings.
4
DIR-610N