Urmet 1093/181WM1 Guía Rápida página 11

IMPORTANT NOTE: the SD card slot is for future developments and cannot be used.
4 ADDING THE CAMERA TO THE WIFI NETWORK
The camera can be configured on the WiFi network in two alternative ways: by temporarily wiring
it to the LAN (see Section 4.1) or in ACCESS POINT mode (see Section 4.2).
To configure the camera, copy the "EasyTool" folder from the CD provided to your PC and follow
the instructions shown in this guide.
Make sure that the PC is already connected (wire or wireless) to the network on which to
configure the camera.
IMPORTANT NOTE: The camera is provided with two different network boards, one for the wire
connection and one for the WiFi connection, each with its own MAC address and is own IP
address.
4.1 WIFI CONFIGURATION VIA CABLED NETWORK
Use a network cable to connect the camera to the LAN and power it. The camera will receive an
IP address assigned automatically by the DHCP service of the network. If the DHCP service is
not available on the network, the camera will automatically assign the default IP 192.168.1.168
to itself.
The following steps are needed for configuration:
1. Start "EasyTool" on the PC by selecting
mask, gateway and MAC address of each IP camera active on the LAN will be
automatically displayed, as shown in the figure below.
2. After having detected the IP camera, right click and select "open in IE" (aprire in IE)
to open a Web page on IE.
DS1093-558
: the IP address, subnet
11