Urmet 1093/181WM1 Guía Rápida página 9

ENGLISH
1 WARNINGS
Video recording
 This device is not designed as a burglar system but mainly to transmit and record video
images. URMET S.p.A. is not in any way responsible for loss or damages of the user
consequent to theft.
 Before using the device, record a demo video to verify the correct functionality of this
feature. URMET S.p.A. is not in any way responsible for loss of recorded data
consequent to wrong setting or usage, device misfunctioning or failure.
This device is composed by electronic precision components. Do not hit the device while

recording as it might affect the video.
Privacy and Copyright
 The IP camera is designed for surveillance systems. Video recording is subject to the
laws applicable to the Country where used.It is forbidden to record images with
Copyright.
 The User is responsible to check and respect all local laws and norms for video signal
recording. The manufacturer is NOT in any way liable for any usage of the product which
might result not compliant to the relevant norms.
Firmware upgrade
Refer to URMET S.p.A. Customer Service Technical Assistance periodically to check

availability of firmware upgrades.
Network configuration
Camera default setting is DHCP mode. If the network does not support dynamic

addressing (DHCP), the device will automatically switch to factory IP 192.168.1.168.
Use Urmet "Easy Tool" software to modify the IP address and other network settings to
prevent any conflict with other devices on the network.
Network connections
When connecting a PC (using Software Client or Browser), any video channel on the

PC will be using "unicast" connection (TCP, RTP, UDP).
The device can support up to 5 "unicast" connections so it is possible to show the video

on maximum 5 remote devices (PC or smartphone) at the same time depending on the
available network band.
Reset button
The camera is equipped with a dual purpose button on the wiring.
 Short press (3-5 seconds): the camera loses network configuration and the WiFi
interface returns to Access Point mode.
 Long press (12-15 seconds): the camera is completely reset and goes back to default
settings.
DS1093-558
9