Auto Code Search - GE 11695 Manual De Instrucciones

input
dvd aux
input
tv cbl
dvd aux
setup
C D
menu
setup
A B
input
C D
dvd aux
setup
exit
input
C D
dvd aux
list
exit
setup
C D
exit
exit
All manuals and user guides at all-guides.com
Programming Your Remote, cont.

Auto Code Search

The Auto Code Search, searches automatically
through all of the codes stored in this remote. Read
all the steps prior to starting the auto code search
tv cbl dvd
as you will need to be prepared to lock-in the proper
input
code when found.
dvd aux
1. Manually turn on the device you wish
to control.
tv cbl dvd
menu
2. Press and hold the SETUP button
until the red indicator light stays on
A B C
setup
(approximately 2 seconds) and then
release the button.
menu
C D
3. Press and release the device button
B C
A
on the remote (TV, CBL, DVD, AUX) the
tv cbl dvd
type of device you wish to control. The
red indicator will blink once and then
remain on.
4. Point the remote at the device and
menu
press and release the POWER button
list
(for TV) or PLAY button (for DVD, VCR,
B C
A
etc.) to start the search. The red
tv cbl dvd
exit
indicator will flash (approximately
every 2 seconds) as the remote
list
searches. Note: The remote must be
pointed at the device for the duration of
menu
this search.
5. Place your finger on the #1 button so
A B C
you are prepared to lock-in the code.
6. When the device shuts off or begins
list
playing, press the #1 button to lock-in
the code. The red indicator light will
turn off. Note: You have approximately
two seconds after the device shuts off
or begins playing to lock-in the code.
7. Point the remote at the device and
check to see if the remote operates the
list
device as desired. If it does, no further
programming is required for that
device. If it does not, return to step 2
and start the auto code
search again.
input
aux
input
aux
setup
D
setup
input
D
aux
setup
exit
input
D
aux
exit
setup
D
exit
exit
8