QV PUSH Owner's Manual
TROUBLESHOOTING
Problem
Abnormal vibration
Will not vacuum or has poor
vacuum performance
Engine will not start
Engine is locked, will not pull
over
Nozzle scrapes ground in
lowest height setting
Part No 831504
Possible Cause
Loose or out of balance impeller or loose engine.
Dirty debris bag. Nozzle height set too high or low. Hose
kit cap missing. Clogged nozzle or exhaust. Excessive
quantity of debris.
Stop switch off. Throttle in off position. Engine not in full
choke position. Out of gasoline. Bad or old gasoline.
Sparkplug wire disconnected. Dirty air cleaner. Low oil
(honda only).
Debris locked in impeller. Engine problem.
Nozzle height out of adjustment.
Check impeller and replace if required.
Check engine.
Clean debris bag. Shake bag clean or
wash. Adjust nozzle height. Check for
hose kit cap. Unclog nozzle or exhaust.
Allow air to feed with debris.
Check stop switches, throttle, choke
position and gasoline. Connect spark
plug wire. Clean or replace air filter. Or
contact a qualified service person.
See page 6. Contact a engine service
dealer for engine problems.
Adjust nozzle height (See Nozzle height
fine adjustment for hard surfaces on page
6.
9
Solution
Form No F102715D