Dmx-512 Connection - Beamz professional BBP66 Uplight Par Manual De Instrucciones

DISPLAY
You can leave every mode by pressing the Menu-button. The functions provided are described later in this manual.

DMX-512 CONNECTION

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
5-pin XLR DMX Connectors.
Some manufactures use 5-pin DMX-512 data cables for DATA transmission in place of 3-pin. 5-pin DMX fixtures may be
implemented in a 3-pin DMX line. When inserting standard 5-pin data cables in to a 3-pin line a cable adaptor
must be used. The chart below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor
Ground/Shield
Data Compliment (- signal)
Data True (+ signal)
Not Used
Not Used
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+) into a 3-pin
XLR connector and plug this into the DMX output of the last fixture in the chain.
IR MODE
Press menu button until Iron or IroF is displayed; then press Up or Down button to
choose Iron. Press ENTER to confirm.
To switch off the lights:
Press OFF on the remote control. All the lights will turn off until the button ON is
pressed [1].
Manual colour control
You can set R/G/B/W colours with the remote by pushing either the Red <R> button for
red, the Green <G> button for green, the Blue <B> button for blue [3].
Each colour intensity is then adjustable using the Light Up and Down [2] buttons
Preset colour mode:
Press one of the twelve preset colours on the remote control [4]. No dimming possible
with preset colours.
AUTO/SOUND on the IRC.
Press one of the four buttons to choose between the different auto programs. [5]
The control board offer several features: you can simple set the starting address, run the pre-
programmed program or make a reset. The main menu is accessed by pressing the Menu-
button, browse through the submenu by pressing
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing
the Enter-button.
3-Pin XLR Female (Out)
Pin 1
Pin 2
Pin 3
or button.
or button. Confirm every selection by pressing
5-Pin XLR Male (In)
Pin 1
Pin 2
Pin 3
Pin 4 – Do Not Use
Pin 5 – Do Not Use
5