Pre-Installation; Tools Required; Materials Required (Not Included) - AquaPRO 40011-3 Manual Del Usuario

18. The motor of this pump has a thermal protector that will trip if the motor becomes too hot. The protector will reset
itself once the motor cools down and an acceptable temperature has been reached. The pump may start
unexpectedly if it is plugged in.
19. Ensure the electrical power source is adequate for the requirements of the pump.
20. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long time
when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt, or debris
may cause the pump to fail. Please carefully read the manual and follow the instructions regarding common pump
problems and remedies.

PRE-INSTALLATION

APPLICATION
41011-3,41021-3,41041-3,41041-2,41051-3,41051-2 are submersible sewage pumps and designed for pumping
sewage, effluent, wastewater or flooded water with up to 2 inch solids.
40011-3 is submersible effluent pump and designed for pumping, effluent, wastewater or flooded water with up to 3/4
inch solids.
The pump is built with overload thermal protections and auto reset. The pump is equipped with a 10' 3-prong
grounding-type power cord and piggyback-style switch for automatic or manual operation. Ball bearings on motor shafts
never need lubrication.

TOOLS REQUIRED

Flathead
Screwdriver
Cable Ties

MATERIALS REQUIRED (NOT INCLUDED)

Threaded Adapter
(Pipe to Pump)
2" Check
Valve
Phillips
Screwdrive
Safety
Goggles
2'' ABS or PVC
Pipe
ABS or PVC
Cement
(to match the pipe)
3
Channel
Locks
Tape
Measure
Thread Tape
Pipe Wrench
Hacksaw
2" 90°
Elbow