Technical Data; Power Requirements - Truper SOMI-130X Instructivo

Technical specifications
Voltage
Current
Welding Process
Open Circuit Voltage
Current Range
Duty Cycle
Output values specified are with a 68 ºF
Micro wire Diameter
Micro wire Speed
Electrode Diameter
Cooling Type
Insulation
Conductors
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
WARNING Before gaining

Power Requirements

WARNING If faults or breakdowns happen. Ground connection offers a
trajectory with minimum resistance for electric power. It reduces the risk of electric
shock. This tool is built with a power cable with an earth conductor and a plug with
ground connection. The plug shall be connected into a power outlet installed and
grounded according to all local codes.
WARNING Do not modify the plug supplied. If the plug cannot be fitted
to the socket, have a qualified electrician to install the suitable socket.
• When using the welder together with more tools using the same ground connect those in parallel, never connect a
series.
CAUTION
• The gauge of the ground conductor cable shall not be of a smaller gauge than the power supply cable.
CAUTION
• Connection to the power supply shall only be carried out by a professional electrician.
CAUTION • Double check the input connection voltage stipulated in the welder nameplate matches the power
supply voltage.
CAUTION • The power supply cord shall meet the following requisites:
Switch
Fuse (Work Rated Current)
Electric Wire
* The current for fuse fusion is double of its rated current.
Code
13191
120 V
24 A
MIG : 30 A - 90 A c.c. | SMAW : 30 A - 70 A c.c.
Temperatures higher than the work cycle may be reduced.
Class I
30 A
30 A ( * )
2,5 mm
2
SOMI-130X
Description
INPUT
Rated Input Capacity
OUTPUT
MIG and SMAW
68 V c.c.
60% - 6 minutes' work per 4 minutes' rest.
0.023" | 0.031"
59 in/min - 334.6 in/min
Tipo: 6013 | 6011
Fan Forced
IP Grade
12 AWG x 3C with 221 °F insulation temperature
Power cord grips used in this product: Type "Y".
Build quality: Basic insulation
Thermal insulation on motor winding: Class F
access to the terminals all power
• If extensions between the welder and the work piece
are needed, the soldering cable gauge shall be increased
to keep the welder energy output with a potential drop
not higher than 4 V
MIG & STICK Multi-Process Welder
Frequency
3/32"
IP21S
Authorized Service Center.
ENGLISH
60 Hz
2,8 kVA
3