Truper SOMI-130X Instructivo página 31

Installation
Torch Connection
• Align the torch connector pins with the power, gas and
micro wire outlets (F) in the torch connection (G) in the
welder front panel. It is important to align all the pins
because they connect electric current, micro wire feeding
system and gas delivery to the torch.
• Once aligned, press the contact connector and turn the
blocking ring ( H ) in a clockwise direction to tighten the
connections.
Micro Wire Spool
CAUTION
• Turn off and disconnect the welder
before opening the cabinet door.
• Push the cabinet locks upwards ( I ) to open and gain
access to the micro wire feeding system.
• Loosen the fastener knob (J) remove the knob, the
spring (O) and the fastener (N) from its axis (K).
• Install the micro wire spool (L) into the axis.
• Set back the fastener (N), then the spring into the
axis (K) and tighten with the knob (J) enough so that
the micro wire spool turns freely.
• Using plyers release the micro wire tip from the
spool notch. Double check the micro wire sticks out
from the lower part of the spool towards the micro
wire feeding mechanism (M).
• Check the micro wire tip is not crooked, bent or it
has alterations or burrs. Cut if necessary in order to
have a straight and flawless tip.
• The micro wire diameter is dependent of the thickness or the material to weld. Small micro wire diameter allows working
with low energy range, deliver less material into the weld and are easy to control, whilst larger micro wire diameter require
more energy to flux the electrode, deliver more material into the weld and are difficult to control.
• The welder can use wires made of different materials and characteristics, like solid wire for gas welding, core wires for
gasless welding or aluminum wire to weld on aluminum. Before installing into the welder, read the manufacturer
specifications of the spool to verify the micro wire is adequate for the job.
• Double check the diameter of torch contact nozzle matches the micro wire diameter installed in the
CAUTION
welder. Otherwise, the micro wire flow can get blocked.
I
O
N
L
J
H
F
K
M
ENGLISH
G
9