Fulgor Milano Sofia PRO-RANGE 30 Serie Instrucciones Para La Instalación página 13

STEP 7
Install the back guard (if provided) by the three screws on the
back. In some cases this may be an accessory back guard
that was ordered separately rather than the one which was
included with the range. Refer to instructions included with any
accessory for specific installation requirements.
STEP 8
After completing the electrical connection (see included
instructions) measure the four corners in cutout area to verify if
flooring is level. Adjust the leveling legs to the desired height
and ensure range is level. Turn the bottom section of each leg
counter-clockwise to raise the leg and clockwise to lower it.
IMPORTANT
When the unit first powers on, it must complete a safety door
lock test. Ensure doors are reinstalled if they were removed
to ease movement of the range prior to sending power to
the appliance. Do not open the oven door or attempt to
use the oven until you are sure the test has been completed
successfully. Opening / closing the door during the test
could result in damage to the lock mechanism. Refer to the
instruction manuals for more details if needed.
Ensure floor is protected. Slide unit into place making sure to
engage the anti-tip bracket.
9" 3"
STEP 9
Hook tabs on bottom of toekick into slots on either side of the
frame and rotate up until the magnets at the top of toekick
make contact and hold it in place securely
4 - Installation Instructions
EN
9