3.4.4 - TURBO function
In TURBO mode, the fan motor functions at a very high speed in a way to reach the temperature set in
the least time possible.
3.4.5 - SELF CLEAN function
In SELF CLEAN mode, the air conditioner automatically cleans and dries the evaporator and keeps it
fresh for successive use.
The function is used on switch off of cooling mode to clean the evaporator and keep it fresh for successive
use.
This function is easy to activate and accessible from the remote control.
The air conditioner will operate as follows:
- Fan only mode with fan at low speed (13 minutes) -
- Heating with fan at low speed (1 minute)
- Fan only operation (2 minutes)
- Stop operation
- Unit switch-off.
This function is only available in COOL (AUTO COOL, FORCED COOL) and DRY modes.
Before selecting this function, it is recommended to start the air conditioner in cooling mode for
Once the Auto Clean function is activated, all timer settings will be annulled.
If the AUTO CLEAN button is pressed again during operation in auto-clean mode, the function
stops and the appliance switches off.
3.4.6 - SILENCE function
This function reduces noise.
3.4.7 - FP function
The FROST PROTECTION function sets the temperature at 8°C.
The function is available in "HEAT" mode only.
3.4.8 - TIMER keys (7 and 8)
These keys are used to set the switch-on "ON" and switch-off "OFF" time of the air conditioner.
3.4.9 - SILENCE/FP key (9)
Press this key for less than 2 seconds to start the SILENCE function.
If the key is held down for more than 2 seconds, the FP (FROST PROTECTION). function is activated.
3.4.10 - SLEEP key (10)
Press this key to access the SLEEP mode; press it again to annul.
The function can be activated only in COOL, HEAT and AUTO modes and allows to maintain the temperature
as comfortable as possible.
When the unit is running in SLEEP mode, this will be annulled if the MODE, FAN SPEED and ON/
OFF keys are pressed.
EN - 31
ARYAL S1 E