Astralpool 42350 Smart+ 60 Manual De Instalación Y Mantenimiento página 4

DESCRIPTION
Standard working voltage
Output (dc)
Production (g/h)
Flow detector
Salinity range / Temperature
Electrodes
Production control
Cover control
Polarity switch
External control
Salt level protection
(1)
Factory default.
(2)
Under ideal conditions: salinity (6 g/l), pH (7.2), water hardness (120 mg/l) and minimum flow rate.
DESCRIPTION
Measurement range
Control range
Precision
Calibration
Control outputs [pH]
pH sensor
Flow detector
3. SAFETY WARNINGS AND RECOMMENDATIONS:_____________________________________________________________________

The equipment should be assembled and handled by truly qualified people.

Current electrical and accident prevention regulations should be followed.

Under no circumstances will the manufacturer be held responsible for the assembly, installation or start-up, nor any handling or
fitting of components unless they are carried out on its premises.

The AstralPool Chlore Salt Electrolysis Systems (42350, 42351, 42352, 52569, 52570, 52571) operate at 230VAC, 50/60 Hz. Do
not attempt to alter the system to operate at a different voltage.

Check all the electrical connectors are well tightened to avoid false contacts and their consequent overheating.

Before installing or replacing any component, disconnect the equipment from the mains, and use exclusively spare parts supplied
by AstralPool.

Taking into account the fact that the equipment produces heat, it must be installed in places with sufficient ventilation. Fan
openings should be kept free of any element that could obstruct then. The equipment should not be installed near flammable
materials.
The AstralPool Chlore Salt Electrolysis Systems (42350, 42351, 42352, 52569, 52570, 52571) have a protection degree of IP24.

They should never be installed in places susceptible to flooding.
If the electrolysis equipment has no cover detection system, it is important to reduce its production to the minimum while the pool is

covered. Otherwise, an excess of chlorine could degrade the pool materials.
Smart+ 60 – Cod. 42350
Smart+PH 60 – Cod. 52569
12 A
10 - 12
Estimated lifetime: 10.000 – 12.000 hours of operation (depending on water quality)
Programmable reduction of production from control panel when closed cover [10 ... 90%]
Programmable from control panel: 2
Two inputs for potential-free contacts for external flow detector and ORP/RESIDUAL CHLORINE
Programmable contact logics from unit control panel
Smart+PH 60 – Code 52569
One output 230 V / 500 mA for dosage pump connection
PPO body, range 0 – 14 (pH), solid electrolyte
PPO Noryl GFN3 Casing / paddle, stainless steel 1,4571 shaft, EPDM O-ring
MODEL
Smart+ 100 – Cod. 42351
Smart+PH 100 – Cod. 52570
230 V AC, 50/60 Hz.
24 A
20 -24
Gas detector + flow switch
o o o
4 – 6 g./l. / +15 C – 40 C (59
SELF-CLEANING coated Titanium
0 – 100 % ( 11 production levels)
Input for potential free contact
(1)
/3 hours + test mode
controller
Automatic production protection
MODEL
Smart+PH 100 – Code 52570
0.0 – 9.9 (pH)
7.0 – 7.8 (pH)
± 0.1 pH
Automatic with calibration solutions
2
Smart+ 160 – Cod. 42352
Smart+PH 160 – Cod. 52571
32 A
25 - 32
o
F – 104 F)
Smart+PH 160 – Code 52571
(2)