Ribimex Ribiland PRBAT20/TH Manual De Instrucciones página 26

- Always remove the battery from the tool in the following circumstances:
-- whenever you leave the tool; when the tool is not in use, is being carried/transported, or is
left unattended.
-- before clearing a blockage; while examining, cleaning or unclogging the tube.
-- before checking, cleaning or working on the product, performing maintenance on it, or
attaching accessories to it.
-- If the device strikes a foreign object (e.g. fence...) or starts to vibrate abnormally.
- If product bumps into any object during operation, stop it and control that it has not been damaged.
Replace or repair any damaged piece in a qualified service centre.
- Use the tool in daylight or with adequate illumination (good artificial light).
- Do not overreach. Keep proper footing and balance at all times.
- Bear in mind that the force generated by an electrical device can make you lose your balance.
Therefore, make sure that your feet are firmly planted and that your body is well balanced when you
are operating the product.
- Never operate the tool on damp areas or wet grass.
- Use of the tool on sloping areas:
-- Do not work in areas with unduly steep slopes.
-- Always be sure of your footing on slopes. Position yourself horizontally to the slope and
make sure your feet are firmly planted.
-- Exercise particular caution whenever you change directions while working on a slope.
- Walk, never run. Walk at a measured pace while operating the tool. DO NOT RUN.
- Keep the ventilation holes (cooling air inlets) unobstructed, clear of debris and clean at all times.
4- Before maintenance and storage
- Keep all nuts, bolts and screws tight to be sure the tool is in safe working condition.
- Check the cutting devices frequently for signs of wear and/or deterioration.
Replace any worn or damaged part.
- Make sure to use only genuine/original replacement parts and accessories.
- For reasons of safety, any worn or damaged component should be replaced or repaired immediately
by a qualified technician.
- When not in use, store the tool only in a dry place that is inaccessible to children.
3.6- In the event of emergency
Stop immediately the tool and remove the battery.
Assist the injured person with first aid and call for medical assistance as quickly as possible.
If electrolyte leaks and contacts skin or eyes, rinse thoroughly with clean water and seek immediate
medical attention.
Page 26 / 81