Maintenance; Seat Cleaning & Removal; Nozzle Cleaning - brondell Swash SE600 Advanced Manual Del Usuario

MAINTENANCE

SEAT CLEANING & REMOVAL
Unplug the Swash from the power source before cleaning or removing the seat.
Use a soft, damp cloth and mild cleanser (such as dish soap, Simple Green or Windex) to wipe
down the seat. DO NOT scrub or use harsh, abrasive products to clean the Swash. DO NOT use
thinner, benzene, acidic chemicals, chloride, or hydrochloric acid detergent. This may result in
corrosion to the metal parts or discoloration or scratches to the bidet body.
For a more thorough cleaning, you may remove the Swash. To remove the bidet, forcefully pull
the bidet away from the toilet tank off of the mounting plate.
NOTE:
• Be cautious of leaving home and beauty products in contact with the bidet seat, the result
of which can be irreversible discoloration. Most stains can be removed using a 1:1 mix of
rubbing alcohol and water and a soft cloth or towel. However, some permanent stains are
the result of substances left on the seat while the seat heater was activated. Be cautious
of home and beauty products (including but not limited to various hair and air freshener
sprays, lotions, body wash, skin tanners, body butters, and oils) that come in contact with
the seat. Wash off any substances that come in contact with the seat as soon as possible. If
necessary, replacement seat parts can be purchased through Brondell customer support.

NOZZLE CLEANING

NOTE:
• The Nozzle Cleaning function will not work if the seat
is occupied.
1. Press and release the Eco Mode and Rear Wash buttons
on the auxiliary control panel simultaneously. The nozzle
will extend into the toilet bowl.
2. Gently clean the nozzle manually with a soft cloth or
toothbrush.
3. To retract the nozzle press the "Stop" button on the
Remote Control.
22
Step 1