brondell Swash SE600 Advanced Manual Del Usuario página 28

TROUBLESHOOTING (cont.)
Problem
Water leaks from
areas other than the
nozzles
26
Possible Cause(s)
1. Water leaking from the T-valve
2. Water leaking from the bidet hose
connection
3. Water leaking from under the seat
4. Water leaking from behind the seat
Solution(s)
1. Make sure that the rubber gasket is
inserted correctly into the T-valve (flat side
down with lip pointing up towards the toilet
tank connection) and firmly tighten the
connector.
2. Make sure that the bidet hose is correctly
connected and tight. Check any rubber
washers and do not over tighten.
3. Check if there is anything between the
mesh filter and bidet. Remove, clean, and
reinstall mesh filter. Check if the filter is
damaged (see maintenance section).
4. Check the water tank plug in the back of
the seat (see maintenance section under
product storage and use).