Honeywell enviracaire PLATINUM HTT-022 Manual De Instrucciones página 2

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HTT-022 OM Eng Rev1.fm Page 2 Thursday, October 19, 2006 12:40 PM
HOW YOUR AIR PURIFIER WORKS
This model air purifier incorporates a 3-stage
cleaning system to help clean the air that passes
through the filter in the unit (Fig. 1).
Stage 1: Washable Pre-Filter
Stage 2: 99% HEPA Permanent Filter
Stage 3: Electronic Ionizer
-
:
SET
UP
• Select a firm, level and flat location. For proper
airflow, locate the unit at least 3 feet (1 M) from
any wall or furniture.
• When operating, large volumes of air are
drawn toward the air purifier. Surrounding
areas should be cleaned and/or vacuumed
frequently to prevent build-up of dust and other
contaminates. This may also help prolong the
life of the filter. If the unit is placed on a light
colored carpet, a small mat or rug should be
used underneath to prevent permanent
staining. This is especially important in homes
with contamination from smoking or fireplaces.
:
INSTALL MAIN FILTER
The Filter is supplied within the air purifier. It is
wrapped to ensure purity.
• Turn-off and unplug the air purifier. While
pressing on the two notches along the front
grille, pull the grille towards you and remove it
(See Fig. 2). Gently push down on the top filter
frame and pull forward.
• Remove the protective wrap from the Filter.
• Place back into the air purifier housing and
snap filter grille into place.
:
Fig. 2
Fig. 1
:
OPERATION
• Ensure the air purifier is plugged into a working
electrical outlet and the Power Knob and
Ionizer Knob are OFF.
• Start and run the air purifier on High for several
minutes and then rotate the Power Knob to the
desired cleaning level.
It is recommended you run your air purifier 24
hours a day to ensure continuous cleaning.
Portable air purifiers are more effective in
rooms where all doors and windows are
closed.
IONIZER FEATURE
The Ionizer helps boost the performance of the air
purifier and helps freshen the air.
Fig. 3
• Turn the Ionizer Control Knob (See Fig. 3) to
the ON position. This will power the Ionizer on.
To turn the Ionizer feature off, simply turn knob
to the OFF position.
2
:

Publicidad

Tabla de contenido
loading

Tabla de contenido