Celestron NexStar 102SLT Manual De Instrucciones página 8

THE STARPOINTER FINDERSCOPE
The StarPointer is the quickest and easiest way to point your telescope exactly at a desired object in the sky It's
like having a laser pointer that you can shine directly onto the night sky The StarPointer is a zero magnification
pointing tool that uses a coated glass window to superimpose the image of a small red dot onto the night sky
While keeping both eyes open when looking through the StarPointer, simply move your telescope until the red dot,
seen through the StarPointer, merges with the object as seen with your unaided eye The red dot is produced by a
light-emitting diode (LED); it is not a laser beam and will not damage the glass window or your eye The StarPointer
comes equipped with a variable brightness control and two axes alignment control Before the StarPointer is ready
for use, it must be attached to the telescope tube and properly aligned
STARPOINTER INSTALLATION
1 Slide the finderscope bracket into the dovetail slot on
the telescope tube near the focuser
2 The large window on the finder should be facing the front
of the telescope
3 Secure the bracket by tightening the setscrew on the
dovetail slot
Your StarPointer finderscope is shipped with a clear plastic
tab inserted between the battery and the contact to prevent
the battery from accidentally being discharged in shipment
Pull this tab out before using your finderscope
ATTACHING THE HAND CONTROL
The NexStar SLT hand control has a phone jack type
connector at the end of its cord Plug the phone jack
connector into the outlet at the base of the telescope's fork
arm Push the connector into the outlet until it clicks into
place and place the hand control into its holder as described
previously in the Assembly section of the manual
On/Off Switch
Auxiliary Port
Hand Control Port
12 V Power Outlet
I 6
ENGLISH