Reset Functions; Special Functions - Briteq BT-W12L10 ZOOM Manual De Instrucciones

ENGLISH
Manual Test
You can check all functions one by one without the need for a DMX-controller.
 Select "Manual Test" and press ENTER.
 The display shows a list with all functions that can be tested.
 Use DOWN / UP buttons to browse the list and press ENTER to select a function.
 Use DOWN / UP buttons to adapt the values: 000 to 255.
 Press MENU to return to the list and choose another function to test.
To stop the test, press the MENU button until you're in the main menu.
Fixture Information
This submenu contains some useful information for servicing.
 Press the MENU button and select the "Fixture Information" submenu.
 The display shows the following information:
 Fixture use Time: shows how many hours the fixture was in use. (reset not possible)
 Lamp On Time: shows how many hours the leds where switched on (can be reset to zero)
 Firmware Version: press MENU to show the software version for the different processors in the unit.
To return, press the MENU button until you're in the main menu.

Reset Functions

This submenu is used to reset the unit or parts of the unit.
 Press the MENU button and select the "Reset Functions" submenu.
 The display shows a list with 3 functions that can be rest: Pan/tilt, Zoom, All.
 Use DOWN / UP buttons to browse the list and press ENTER to select a function.
 Use DOWN / UP buttons to confirm your choice: Yes or No.
 Press MENU to return to the list and choose another function.
To return, press the MENU button until you're in the main menu.

Notice an alternative shortcut for this function: press the MENU & ENTER buttons together
for 3seconds.

Special Functions

This submenu contains some useful functions for servicing.
 Press the MENU button and select the "Special Functions" submenu.
Fixture Maintenance
Used to set/reset the interval time between successive maintenances.
 Select "Fixture Maintenance" and press ENTER.
 Two options are available:
 Interval: here you can set the desired time between 2 maintenances.
 Use DOWN / UP buttons to change the interval between 10 and 300hours.
 Press ENTER to confirm
 Remain Time: shows how many hours are still left before the next maintenance.
 When maintenance is done, use DOWN / UP buttons to reset the timer.
 Press ENTER to confirm
 To return, press the MENU button until you're in the main menu.
Factory Settings
This is your emergency exit if you really messed up the settings: just return to factory settings.
No: keep the current settings unchanged.
Yes: return to factory settings, personal settings are lost.
 Select "Factory Settings" and press ENTER
 Use DOWN / UP buttons to select Yes or No.
 Press the ENTER button to save.
To return without any change or go to a previous menu, press the MENU button.
BRITEQ
®
7/73
OPERATION MANUAL
BT-W12L10 ZOOM